Friday, September 23, 2011

Buy A Whirlpool Tub

Up to your neck in hot water with all this confusion about jets and pumps? Not to worry. Once you choose between an air-jet bathtub and a whirlpool system, your cares will bubble away. Does this Spark an idea?


Instructions


1. Choose a tub system. In air-jet tubs, air is propelled through dozens of small holes for an all-over bubbling action. In whirlpool tubs, air and water is forced through four to eight large jets for a vigorous massaging action. These powerful jets open, close and swivel to adjust pressure and flow. Smaller jets may cycle along the backrest or target the feet or neck.


2. Figure out where the tub will go. Easiest to install are 5-foot (1.5 m)-long models that slide into your existing tub alcove. Recess-mount tubs fits between walls, which butt against the tub rim. Deck-mount tubs drop into the floor or a platform, requiring a tiled surround. Corner tubs maximize floor space.


3. Make sure your water heater is large enough to fill about twothirds of your tub with warm water. Whirlpool tubs vary in size, holding 25 to 150 gallons (95 to 560 liters) of water.


4. Test size, back support and comfort in showroom models. To accommodate short and tall people, compromise on a tub about 5 1/2 feet (1.7 m) long by 33 to 42 inches (84 to 107 cm) wide. Before buying a giant tub for two, think how often you'll share it, since you'll be paying to heat a lot of water.


5. Weigh your tub options. Enameled cast iron is durable but heavy-- make sure your floor can support it. As for lightweight plastic, molded acrylic resists stains better than sprayed-on gelcoated fiberglass tubs. Easy-care enameled steel tubs come in just a few sizes and shapes.


6. Make sure you have access to the components. All mechanical tubs require maintenance access via an apron or a panel in the tub surround. Whirlpool tubs may require a large opening to reach pipes; air-jet systems need motor access only.


7. Pay attention to the details: Look for protected jets, and sensors that cut the motor if the water is low, so the motor won't burn out. Built-in grab bars and slip-resistant floors add safety. Units with internal water heaters maintain a consistent temperature.


8. Determine if you want a self-cleaning system. Because whirlpool tubs recirculate water, their systems need frequent cleaning. Some air-jet systems automatically purge bacteria-causing residue after each use.


9. Consider your budget. Whirlpool and air-jet tubs sell for anywhere from less than $1,000 to more than $20,000, depending on system, size, materials used and other options.







Tags: air-jet systems, air-jet tubs, Make sure, sure your, systems need